Playset style tower walls
These are walls and a dungeon floor that make it possible to open the walls of your tower like a cabinet¸ so that you dont need to take the tower completely apart to use it. Instead¸ it opens like a "playset". the floors can optionally stay attatched to the swinging walls to make it easier to access the decor and miniatures inside¸ if so desired¸ or¸ you can open just the walls to retain the round room effect. any Fat Dragon Games floors will work with the walls¸ so if you want a pit trap floor¸ you can place a cage underneath¸ or a hazard¸ and get the full effect. or¸ stairs can run up from one floor to the next. While open¸ you can even use an extra floor piece to make a unique walkway. There are versions of walls that are normal¸ save for the round pin holes to be used if you desire to leave the floor connected¸ or there are walls divided up into two pieces so that a post stays behind to support the floor. the pins should be printed at 100% infill¸ as they will be under stress while in use. the walls and floor¸ I print at.2 with 15% infill. If you want to have only one opening level¸ then you will need 3 normal walls and two pins. If you want all opening levels¸ then you need a pin between each level. The tops will be used to hold everything in place. Alternatively¸ there is a clip that can be used to go from a square hole to a round hole. Get creative and find new ways to build!